This product cannot ship by Air. Contact us for shipping options and charges.
DocumentationSDS and COA
SDS | COA
Analytes
Analyte
CAS Number
Target Concentration
1,2-Dibromoethane
106-93-4
N/A
Structure
Properties
Molecular FormulaMol. Formula
C2H4Br2
Molecular WeightMol. Weight
187.86
Melting PointMelting
10 °C
Boiling PointBoiling
132 °C
Flash PointFlash Pt.
Noncombustible
Safety Information
Refer to SDS for detailed product information.
Symbol
Signal word
Danger
Hazard statements
May cause kidney and liver damage. (Specific target organ toxicity, single exposure, category 2) Toxic if absorbed through skin. (Acute toxicity, dermal, category 3) Toxic if swallowed. (Acute toxicity, oral, category 3) Harmful if inhaled. (Acute toxicity, inhalation, category 4) Irritating to skin. (Skin corrosion/irritation, category 2) Irritating to eyes. (Eye damage/irritation, category 2B) This product is or contains a component that is classified (ACGIH, IARC, NTP, OSHA) as a possible cancer hazard. (Carcinogenicity, category 1B) California Proposition 65 Warning: This product contains a component (or components) that may cause cancer and genetic effects in a concentration greater than or equal to 0.1%.
Precautionary statements
Eye contact: Immediately flush with plenty of water. After initial flushing, remove any contact lenses and continue flushing for at least 15 minutes. Assure adequate flushing by separating the eyelids with fingers. (P338) Skin contact: Immediately wash skin with soap and plenty of water. Remove contaminated clothing. Get medical attention if symptoms occur. Wash clothing before reuse. (P360) Ingestion: Do NOT induce vomiting. Call a physician or poison control center immediately. Never give anything by mouth to an unconscious person. (P331) Store in a tightly closed container. (P404) Store in a cool dry place. (P235) Do not breathe vapor. (P260) Do not get in eyes, on skin or clothing. (P262) This product should only by used by persons trained in the safe handling of hazardous chemicals. (P202) Wash thoroughly after handling. Do not take internally. Eye wash and safety equipment should be readily available. (P264) Respiratory Protection: If workplace exposure limit(s) of product or any component is exceeded (see TLV/PEL), or a risk assessment shows air-purifying respirators are appropriate, use of a NIOSH/MSHA approved air supplied respirator is advised. Use a full-face respirator with multi-purpose combination (US) or type ABEK (EN14387) respirator cartridges in absence of proper environmental control. Always use respirators and components tested and approved under appropriate government standards such as NIOSH (US) or CEN (EU). Engineering and/or administrative controls should be implemented to reduce exposure. Protective gloves must be worn to prevent skin contact. (P280)