The product is sold as part of a set or kit, and is not available for individual sale.
DocumentationSDS and COA
SDS | COA
Structure
Properties
Molecular FormulaMol. Formula
C6H6
Molecular WeightMol. Weight
78.11
Melting PointMelting
5.5 °C
Boiling PointBoiling
80.1 °C
Flash PointFlash Pt.
12 °F (-11 °C) (cc)
Safety Information
Refer to SDS for detailed product information.
Symbol
Signal word
Danger
Hazard statements
May cause heritable genetic damage. (Germ cell mutagenicity, category 1) Harmful to fish and other water organisms. (H402) Danger of serious damage to health by prolonged exposure. (Specific target organ toxicity, repeated exposure, Category 1) Aspiration hazard if swallowed - may be fatal if swallowed and enters airways. (Aspiration hazard, category 1) Highly Flammable (Flammable liquids, category 2) Harmful if swallowed. (Acute toxicity, oral, category 4) Harmful if inhaled. (Acute toxicity, inhalation, category 4) Irritating to skin. (Skin corrosion/irritation, category 2) May be irritating to mucous membrane and upper respiratory system. (Specific target organ toxicity, single exposure; Respiratory tract irritation, category 3) This product is or contains a component that is classified (ACGIH, IARC, NTP, OSHA) as a cancer hazard. (Carcinogenicity, category 1A) California Proposition 65 Warning: This product contains a component (or components) that may cause cancer and genetic effects in a concentration greater than or equal to 0.1%.
Precautionary statements
Eye contact: Immediately flush with plenty of water. After initial flushing, remove any contact lenses and continue flushing for at least 15 minutes. Assure adequate flushing by separating the eyelids with fingers. (P338) Skin contact: Immediately wash skin with soap and plenty of water. Remove contaminated clothing. Get medical attention if symptoms occur. Wash clothing before reuse. (P360) Ingestion: Do NOT induce vomiting. Call a physician or poison control center immediately. Never give anything by mouth to an unconscious person. (P331) Store in a tightly closed container. (P404) Do not get in eyes, on skin or clothing. (P262) This product should only by used by persons trained in the safe handling of hazardous chemicals. (P202) Wash thoroughly after handling. Do not take internally. Eye wash and safety equipment should be readily available. (P264) Respiratory Protection: If workplace exposure limit(s) of product or any component is exceeded (see TLV/PEL), or a risk assessment shows air-purifying respirators are appropriate, use of a NIOSH/MSHA approved air supplied respirator is advised. Use a full-face respirator with multi-purpose combination (US) or type ABEK (EN14387) respirator cartridges in absence of proper environmental control. Always use respirators and components tested and approved under appropriate government standards such as NIOSH (US) or CEN (EU). Engineering and/or administrative controls should be implemented to reduce exposure. Protective gloves must be worn to prevent skin contact. (P280)
