Click "Allow Cookies" to consent to storing cookies on your device to improve your experience on our site. Learn more.
Methyl methacrylate monomer
CAS# 80-62-6
Catalog NumberCat#
ALR-129N
17034 Classification17034 Class.
Certified Reference Material
Number of ComponentsComps.
1
Unit
100 mg
Price (USD) Price
$10.00
Additional Information
Storage ConditionStorage
Ambient (>5 °C)
Safety Data SheetSDS
Certificate of AnalysisCOA
Lot Number: DownloadGo
Analytes
Analyte | CAS Number | Target Concentration |
---|---|---|
Methyl methacrylate | 80-62-6 | N/A |
Structure
Properties
Molecular FormulaMol. Formula
C5H8O2
Molecular WeightMol. Weight
100.12
Melting PointMelting
-48 °C
Boiling PointBoiling
98 - 100 °C
Flash PointFlash Pt.
48.2 °F (9 °C) (cc)
Safety Information
Refer to SDS for detailed product information.
Symbol
Signal word
Danger
Hazard statements
May cause skin sensitization. (Sensitization, skin, category 1)\nHighly Flammable (Flammable liquids, category 2)\nIrritating to skin. (Skin corrosion/irritation, category 2)\nIrritating to eyes. (Eye damage/irritation, category 2B)
Precautionary statements
Eye contact: Immediately flush with plenty of water. After initial flushing, remove any contact lenses and continue flushing for at least 15 minutes. Assure adequate flushing by separating the eyelids with fingers. (P338)\nSkin contact: Wash thoroughly with soap and water. Get medical attention if irritation develops or persists. (P352)\nInhalation: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical attention. (P340)\nIngestion: Do NOT induce vomiting. Call a physician or poison control center immediately. Give victim a glass of water a little at a time. Never give anything by mouth to an unconscious person. If vomiting occurs spontaneously, lower head below waist to prevent fluid from entering the lungs. (P331)\nEvacuate the area of all non-essential personnel. Wear a self-contained breathing apparatus and appropriate personal protection. Eliminate any ignition sources until the area is determined to be free from explosion or fire hazards. Contain the release and eliminate its source, if this can be done without risk. Take up and containerize for proper disposal. Comply with Federal, State, and local regulations. (P380)\nStore in a tightly closed container. (P404)\nDo not breathe vapor. (P260)\nDo not get in eyes, on skin or clothing. (P262)\nThis product should only by used by persons trained in the safe handling of hazardous chemicals. (P202)\nWash thoroughly after handling. Do not take internally. Eye wash and safety equipment should be readily available. (P264)\nRespiratory Protection: If workplace exposure limit(s) of product or any component is exceeded (see TLV/PEL), or a risk assessment shows air-purifying respirators are appropriate, use of a NIOSH/MSHA approved air supplied respirator is advised. Use a full-face respirator with multi-purpose combination (US) or type ABEK (EN14387) respirator cartridges in absence of proper environmental control. Always use respirators and components tested and approved under appropriate government standards such as NIOSH (US) or CEN (EU). Engineering and/or administrative controls should be implemented to reduce exposure.\nProtective gloves must be worn to prevent skin contact. (P280)
Transport Information
UN NumberUN #
UN1247
Hazard ClassHaz Class
3
Packing GroupPacking
II