Highly Flammable (Flammable liquids, category 2) Harmful if swallowed. (Acute toxicity, oral, category 4) Harmful if inhaled. (Acute toxicity, inhalation, category 4) Irritating to skin. (Skin corrosion/irritation, category 2) Harmful if absorbed through skin. (Acute toxicity, dermal, category 4) Irritating to eyes. (Eye damage/irritation, category 2B) May be irritating to mucous membrane and upper respiratory system. (Specific target organ toxicity, single exposure; Respiratory tract irritation, category 3) This product is or contains a component that is classified (ACGIH, IARC, NTP, OSHA) as a suspect cancer hazard. (Carcinogenicity, category 2)
Precautionary statements
Eye contact: Immediately flush with plenty of water. After initial flushing, remove any contact lenses and continue flushing for at least 15 minutes. Assure adequate flushing by separating the eyelids with fingers. (P338) Skin contact: Immediately wash skin with soap and plenty of water. Remove contaminated clothing. Get medical attention if symptoms occur. Wash clothing before reuse. (P360) Inhalation: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical attention. (P340) Store in a tightly closed container. (P404) Do not breathe vapor. (P260) Do not get in eyes, on skin or clothing. (P262) This product should only by used by persons trained in the safe handling of hazardous chemicals. (P202) Wash thoroughly after handling. Do not take internally. Eye wash and safety equipment should be readily available. (P264) Respiratory Protection: If workplace exposure limit(s) of product or any component is exceeded (see TLV/PEL), or a risk assessment shows air-purifying respirators are appropriate, use of a NIOSH/MSHA approved air supplied respirator is advised. Use a full-face respirator with multi-purpose combination (US) or type ABEK (EN14387) respirator cartridges in absence of proper environmental control. Always use respirators and components tested and approved under appropriate government standards such as NIOSH (US) or CEN (EU). Engineering and/or administrative controls should be implemented to reduce exposure. Protective gloves must be worn to prevent skin contact. (P280)
